Panasonic DMR-EX77 - Manual (Page 72)

72
RQT8859
Changing the unit’s settings
Refer to the control reference on page 64.
You can restart auto channel setting for terrestrial digital and
analogue channels if set up (
➡ 20) fails for some reason.
However, if you perform “Auto-Setup Restart”, the order of analogue
channels will change.
After performing steps 1–4 (
➡ 69)
5
Press [ 3, 4] to select “Auto-Setup
Restart” and press [OK].
The confirmation screen appears.
6
Press [ 2, 1] to select “Yes” and
press [OK].
You can also use the following method to restart Auto-Setup.
When the unit is on and stopped,
Press and hold [
X CH] and [CH W] on the main unit until the
Auto-Setup screen appears.
All the settings except for the ratings level, ratings password and
clock settings return to the factory preset. The timer recording
programmes are also cancelled.
To return to the previous screen
Press [RETURN].
To exit the screen
Press [EXIT].
List of TV Reception Channels
Change the setting to match the equipment you are connecting with,
or to match the title when there are both PAL and NTSC titles on the
HDD.
1
While stopped
Press [FUNCTION MENU].
2
Press [ 3, 4] to select “To Others”
and press [OK].
3
Press [ 3, 4] to select “Setup” and
press [OK].
4
Press [ 3, 4] to select “Connection”
and press [ 1].
5
Press [ 3, 4] to select “TV System”
and press [OK].
6
Press [ 3, 4] to select the TV system
and press [OK].
≥PAL (factory preset)
–Select when connecting to a PAL or Multi-system
television. Titles recorded using NTSC are played as PAL
60.
–Select to record television programmes and PAL input from
other equipment.
– [HDD] Select when playing a PAL input title recorded on the
HDD.
≥NTSC
–Select when connecting to a NTSC television. Television
programmes cannot be recorded properly.
–Select to record NTSC input from other equipment.
–
[HDD] Select when playing a NTSC input title recorded on
the HDD.
7
Press [ 2, 1] to select “Yes” and
press [OK].
To return to the previous screen
Press [RETURN].
To exit the screen
Press [EXIT].
∫ To change the setting all at once (PAL !# NTSC)
While stopped, keep pressing [ ∫] and [< OPEN/CLOSE] on the
main unit simultaneously for 5 or more seconds.
[Note]
≥This unit cannot record NTSC signals to discs that already have
PAL signal recordings. (However, both types of programmes can
be recorded onto the HDD.)
≥If “NTSC” has been selected, the TV Guide system cannot be
used.
Auto-Setup Restart
Tuner
System
Channel
Coverage
VHF UHF CATV
PAL–B
Australia
Analogue
0–12 28–69
45 MHz to
470 MHz
DVB–T
Australia
Digital
6–12 27–69 –
TV System
Setup TV System
PAL
NTSC
Disc
Picture
Sound
Display
Tuning
Connection
Others
OK RETURN
SELECT
EX77_87GN.book Page 72 Wednesday, May 30, 2007 1:10 PM