Paxar MO 9742 - Manual (Page 19)

36
MO9740 Manual
Parallel Interface Requirements
The required cable (IEEE 1284-compliant is recommended) must
have a standard 36-pin parallel connector on one end, which is
plugged into the parallel port located on the back of the printer. The
other end of the parallel interface cable connects to the printer
connector at the host computer. For pin-out information, refer to
the Reference Technical Information- Interface Specification.
Serial and Parallel Cabling Requirements.
Data cables must be of fully shielded construction and fitted with
metal or metalized connector shells. This will help to prevent
radiation and reception of electrical noise.
To minimize electrical noise pickup in the cable:
■Keep data cables as short as possible
■Do not tightly bundle the data cables with power cords.
■Do not tie the data cables to power wire conduits.
Notes :
1. Using Centronics allows for a much higher speed
communication than the use of a serial.
2. It is not necessary to set the switch or send any command
to select the parallel or serial port. The printer can
automatically detect it.
3. The default settings can be read from the configuration report
37
MO9740 Manual
11. Communicating with the Printer
The bundled printer driver can be applied to all the applications
under Windows 98/ME/2000/XP, and Windows NT. Through this
driver you may run any popular software applications e.g.
MS-Word and print out the contents by this label printer as long as
they are for Windows.
Before installation
1. Check the contents of the driver to ensure it is complete.
2. Make a backup copy of this driver.
3. Read the read.txt file for installation guide and change notices.