Panasonic CY-RC50KN - Manual (Page 19)

 Adjust the camera angle so that the fender or the rear edge of the vehicle
appears at the bottom of the monitor.
 Attach the camera bracket to a glass or painted surface on the vehicle
body.
Side view
 Mount the camera body onto the camera bracket.
Bolt with washer
Hexagon wrench
Rear view camera
Side with logo
uppermost
The screw holes to use, and the possible angle
adjustment, vary according to the mounting
position.
Mount on the screw holes
on the side opposite
the direction of forward
motion.
Direction
of forward
motion
Camera fi eld of view
Approx. 103°
Approx. 134°
Use the Hexagon wrench
to loosen the bolts, then
adjust the camera angle.
(After adjusting, tighten the
bolts securely.)
45°
90°
 Peel the backing paper and press the camera
bracket fi rmly onto the surface.
O Do not touch the bonding
surface with your hands.
O Do not re-attach the
adhesive.
Mount on the screw holes
below the camera.
Direction
of forward
motion
Logo
90°
0°
Logo
 Form the camera bracket to
fi t the form of the mounting
surface. (Do not remove the
backing paper)
Camera bracket
Fender or the rear edge of
the vehicle