Panasonic CY-RC50KN - Manual (Page 3)

Observe the following cautions
when using this unit.
R Do not use this system for any purpose other
than mounting on a road vehicle.
Non-vehicular use (such as use outdoors
or on a pleasure boat) could cause smoking
generation, ignition, electric shock, injury and
breakdown.
R
Do not use an automatic car–washing
machine to wash the vehicle.
Exposure to water from a high pressure hose
or impact from a brush may cause the system
to fall resulting in accident or injury. Water
entering inside the camera can result in a fi re,
electric shock or breakdown.
Observe the following cautions
when installing.
R Do not damage cords.
Do not damage, pull, bend, twist or modify
cords, place heavy objects on them, or place
them near hot equipment or in contact with
hot parts of the vehicle. Breaking or shorting
cords could cause fi re, electric shock, or
accidents.
O Route cords so that they cannot be pinched
by the body of the vehicle, screws or
moving parts (seat rails etc.).
O Do not press cords with the point of a
screwdriver or similar implement.
Caution
R Do not damage the rear view camera cord.
Water and moisture can move along the cord
from the damaged area and enter the camera,
causing fi re, electric shock and breakdown.
R Route the rear view camera cord inside
the vehicle, so that water cannot penetrate
them.
If water enters the vehicle during rain or car
washing, it could cause fi re or electric shock.
R Order wiring, mounting and dismounting
work from a specialist engineer.
Wiring, mounting and dismounting work
requires specialist skills and experience. For
safety, ask your dealer to perform such work.
In the case that this system is installed in a
vehicle with a drive computer or a navigation
system, improper removal of the battery may
result in erasure of system’s memory.
R Only use the accessories provided and the
parts specifi ed.
Use of non-specifi ed parts can cause internal
damage to the equipment, and insecure
mounting could allow it to fall off, causing
accident, breakdown and fi re.
R Mount the equipment securely, so that it
cannot come off and fall.
Wipe the mounting area clean of dirt, wax
etc., then fasten the camera securely in place.
Re-affi xing adhesive parts or use of general-
purpose double-sided tape could cause weak
bonding that would allow the equipment to
drop off while the vehicle is in motion, causing
accident or injury. Check the state of bonding
or mounting (loose screws etc.) occasionally.