Philips 9160XL - Manual (Page 12)

ENGLISH 23
Once A Month: Razor Heads
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. Philips Norelco Razor Cleaner, model
RC1776, or rubbing alcohol) and lubricated with
Philips Norelco Razor Lubricant, model AL80, or
one drop of mineral oil (in the center of the
head). This helps prevent wear of the shaving
heads.
After Each Use: Trimmer
1 Turn razor OFF.
2 Push down spring-release trimmer switch.
C
3 Clean trimmer with the brush every time
you use it.
C
4 Lubricate the trimmer teeth with Philips
Norelco Razor Lubricant (model AL80) or
with one drop of mineral oil every 6
months.
5 Close trimmer by pressing trimmer down.
This razor has no other user-serviceable parts.
Any other service should be performed by the
Philips Norelco Service Location.
ENGLISH 22
C
4 Remove and clean one set of cutters and
combs at a time.
C
5 Separate the cutter from the comb and
rinse clean under hot water.
Do not clean more than one cutter and comb at
a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
C
6 Replace the set back into the Razor Head
Assembly so that the ‘wings’ on the comb
fit within the brackets located towards the
center of the Assembly.
The set will only fit into the Razor Head Assembly
if the ‘wings’ are between the brackets. Make sure
that the two pointy edges of the head fit exactly
into the recesses.
7 Repeat the process for the other two sets
of cutters and combs.
8 Replace the frame.
C
9 Press down (1) and turn wheel clockwise
(2) until it locks into place.
10 Close the Razor Head Assembly.