Panasonic PRO-SW100P - Manual (Page 5)

5
1. Separate the conductors for a
length of about 2 inches on the
end of each wire. Then strip
1 /
2
inch of insulation from the ends of
each conductor and twist the wire
ends.
2. Position each wire end between
the open barrel ends of a Speaker
Pin.
3. Using a pair of pliers, crimp down
the open barrel ends of the
Speaker Pin to hold the wire end
in place.
4. Plug the Speaker Pin into the
proper HIGH LEVEL OUTPUT termi-
nal on the PRO-SW100P.
CONNECTING TO
POWER
Plug the PRO-SW100P’s AC power
cord into an AC outlet. The STANDBY
indicator lights green. If the subwoofer
does not receive a signal for about 11
minutes, the STANDBY indicator lights
red.
ADJUSTING THE
VOLUME
Once you have made all connections,
follow these steps to adjust the PRO-
SW100P’s volume.
1. Rotate VOLUME CONTROL to MIN .
2. Turn on your amplifier/receiver
and another component (such as
a radio, cassette player, CD
player, or turntable).
3. Begin play of an audio source
(such as a radio) and adjust the
amplifier/speaker’s overall volume
to a comfortable level. Rotate
VOL-
UME CONTROL clockwise, a little
at a time, until you achieve a
pleasing balance of bass between
the PRO-SW100P and the main
speakers (and satellite speakers, if
used). Bass output should not
overpower the main speakers, but
should blend across the entire
musical range.
Once you have adjusted VOLUME
CONTROL , use the amplifier/receiver’s
volume control to control the speakers’
volume.
To PRO-SW100P
From left or right speaker
AC120V
60Hz
STANDBY
40-4080.fm Page 5 Wednesday, August 11, 1999 10:58 AM