Panasonic TZ-PCD3000 - Manual (Page 5)

5 1 2 3 4
Rear Panel
10 6
7
8
9
5
1
2
3
4
10
6
7
8
9
11
12
11
12
CABLE IN
CABLE OUT
DIGITAL AUDIO
COAX OUT
AC Power Input
AUDIO OUT
VIDEO OUT
S-VIDEO OUT
DIGITAL AUDIO
OPT OUT
IR BLASTER
SERIAL port
AC Switched
Outlet
Use to connect Cable Signal input from Cable
Service Provider.
Use to connect the Digital CATV Terminal out-
put to your TV or VCR.
The COAXIAL S/PDIF connector is a digital out-
put connection that carries Dolby Digital (up to
5.1ch) audio or PCM audio.
Use to connect a peripheral equipment to the
Digital CATV Terminal.
Use to connect the Digital CATV Terminal to an
AC electrical outlet with AC cord (included).
Use to connect the Digital CATV Terminal au-
dio output to your TV with stereo sound, or VCR
with stereo sound.
AUDIO OUT1 is for TV, and the volume is variable.
AUDIO OUT2 is for VCR, and the volume is fixed
.
Use to connect the Digital CATV Terminal video
output to your TV or VCR.
Use to connect the Digital CATV Terminal S-
video output to your TV with S-VIDEO, or VCR
with S-VIDEO.
The OPTICAL S/PDIF connector is an optical
digital output connection that carries Dolby Digi-
tal (up to 5.1ch) audio or PCM audio.
When an IR BLASTER cable unit is connected
to this terminal, this terminal can output remote
control signals for recording images from a video
deck that is connected to the Digital CATV Ter-
minal
This terminal can be used to send and receive
data between the Digital CATV Terminal and
other equipment.
(do not connect your PC to this SERIAL port.)
Use to connect the power cord plug of some
other component such as a TV.
(120 V AC, 60 Hz, 5 A)
Please use within specification.
USB SERIAL
DIGITAL AUDIO
COAX OUT
IR
BLASTER
CABLE IN
VIDEO
VIDEO R-AUDIO-L OUT2
OUT1 S-VIDEO
SWITCHED AC OUT
120V~60Hz 5A
AC IN
120V~60Hz
CABLE OUT
R-AUDIO-L OPT
OUT Note:
USB Port
(Universal Serial
Bus)