Specifications, Chip dlp™ projector – Panasonic PT-DW10000 User Manual
Page 2
S
P
E
C
F
I
L
E
PT-DW10000
3-Chip DLP™ Projector
As of November 2008
< 2 >
Specifications
Main Unit
Power supply:
North America:
Europe, Asia
Power consumption:
DLP™ chip:
Panel size:
Display method:
Pixels:
Lens:
Lamp:
Screen size:
Brightness *
1
:
Center-to-corner uniformity *
1
:
Contrast *
1
:
Resolution:
Scanning frequency:
RGB:
YP
B
P
R
(YC
B
C
R
):
S-Video/Video:
Optical axis shift*:
Vertical:
Horizontal:
Keystone correction range:
Installation:
Terminals: DVI-D
IN:
RGB1 IN:
R, G, B:
Y, P
B
, P
R
RGB2 IN:
R, G, B:
Y, P
B
, P
R
VIDEO IN:
120 V AC, 15 A, 60 Hz
220–240 V AC, 15 A, 50/60 Hz
1,450 W (25 W in standby mode with fan stopped)
0.95˝ diagonal (16:9 aspect ratio)
DLP™ device x 3 (R, G, B), DLP™ projection system
2,073,600 (1,920 x 1,080) x 3, total of 6,220,800 pixels
Optional powered zoom/focus lenses
250 W UHM lamp x 4
70 – 600 inches, 16:9 aspect ratio
(70 – 300 inches with the ET-D75LE5, 16:9 aspect ratio)
10,000 lumens (four-lamp operation mode)
90%
5,000:1 (full on/full off, in dynamic iris 3 mode)
1,920 x 1,080 pixels (Input signals that exceed this resolution will be
converted to 1,920 x 1,080 pixels.)
Horizontal: 15 –100 kHz, Vertical: 24 – 120 Hz*
2
,
Dot clock: 20–162 MHz
480i: f
H
15.75 kHz; f
V
60 Hz, 576i: f
H
15.63 kHz; f
V
50 Hz,
480p: f
H
31.50 kHz; f
V
60 Hz, 576p: f
H
31.25 kHz; f
V
50 Hz,
720/60p: f
H
45.00 kHz; fV 60 Hz, 720/50p: f
H
37.5 kHz; fV 50 Hz,
1035/60i: f
H
33.75 kHz; f
V
60 Hz, 1080/60i: f
H
33.75 kHz; f
V
60 Hz,
1080/50i: f
H
28.13 kHz; f
V
50 Hz, 1080/25p: f
H
28.13 kHz; f
V
25 Hz,
1080/24p: f
H
27.00 kHz; f
V
24 Hz, 1080/24sF: f
H
27 kHz; f
V
48 Hz,
1080/30p: f
H
33.75 kHz; f
V
30 Hz, 1080/60p: f
H
67.5 kHz; f
V
60 Hz,
1080/50p: f
H
56.25 kHz; f
V
50 Hz
Horizontal: 15.75/15.63 kHz, Vertical: 50/60 Hz,
(NTSC, NTSC4.43, PAL, PAL60, PAL-N, PAL-M, SECAM)
±60% (±50% with the ET-D75LE6) from center of screen, powered
±20% (±15% with the ET-D75LE6) from center of screen, powered
Vertical: ±40° (±22° with the ET-D75LE5, ±28° wih the ET-D75LE6)
Ceiling/floor, front/rear
DVI-D 24-pin x 1, DVI 1.0 compliant, HDCP compatible, single link
BNC x 5
G: 0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms,
B, R: 0.7 Vp-p, 75 ohms
HD, VD, SYNC: 1.4–5.0 Vp-p, positive/negative automatic
Y: 1.0 p-p, 75 ohms (incl. sync signal), P
B
/P
R
: 0.7 Vp-p, 75 ohms
0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms
NOTE: HD/SYNC, and VD terminals do not accept 3-value direct sync signals.
D-sub HD 15-pin x 1
0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms
HD, VD, SYNC: TTL, high impedance, positive/negative automatic
VD: 1.4–5.0 Vp-p, positive/negative automatic, 75 ohms
Y: 1.0 p-p, 75 ohms (incl. sync signal), P
B
/P
R
: 0.7 Vp-p, 75 ohms
NOTE: HD/SYNC, and VD terminals do not accept 3-value direct sync signals.
BNC x 1, 1.0 Vp-p, 75 ohms