Polycom SpectraLink NetLink DCX100 User Manual

Page 26

Advertising
background image

SpectraLink Corporation

NetLink e340/h340/i640 Wireless Telephones and Accessories User Guide

Part Number: 72-1004-01-J.doc

Page 26

Incoming PBX call

during a PTT call

A telephone call may be answered while in a PTT call session. To
announce an incoming call, the NetLink Docking Station will ring
with a low-volume ring and display the system message.
To answer the call, press the

Start Call

button, the

SPKR

button, or

lift the handset. The PTT call session will be pre-empted and no
PTT audio will be heard.
After the PBX call is over, press the

Start Call

button, the

SPKR

button,

or hang up the handset as usual to go back on hook, at

which time PTT goes out of pre-empted mode and becomes active
again. If an already active PTT call has not ended, the PTT audio
starts playing again.
If the user does not answer the telephone call by pressing the

Start

Call

button, the

SPKR

button or lifting the handset, the PTT display

will be shown after the ring has stopped.

Making a PBX call

during a PTT call

To start a telephone call during a PTT call session, press the

Start

Call

button, the

SPKR

button, or lift the handset. This causes the

two-way radio to be pre-empted as described above.

Docking Station Charging Unit

The docking cradle of the NetLink s340 Docking Station and

NetLink s640 Docking Station acts as a charger for the handset.
This docking cradle is designed to charge the Nickel Metal Hydride
(NiMH) Battery Packs. Full charging is accomplished in
approximately one and a half hours.
See the section Cleaning the Chargers for information on the care of
the docking cradle charging unit in the Docking Station.

Using the docking cradle Place the NetLink e340/h340/i640 Wireless Telephone into the

Docking Station slot facing forward. When the handset is turned on

and correctly inserted, the

Use Deskset

display will appear and

functionality will be transferred to the NetLink Docking Station.
The handset will immediately begin charging.

You can place the handset in the docking cradle while in a call and

the call is transferred to the NetLink Docking Station, in

speakerphone mode (as shown by the

SPKR

LED lighting up). You

can then lift the handset to continue the conversation over the
handset if desired.

Charging indicator If the handset is in standby mode, it will display

Use Deskset

and

Charging. . .

. If the handset is turned off, only

Charging. . .

will

display. The dots will be racing during the charging cycle. It is
normal for the Battery Pack to become warm when charging.

Charge Complete When the handset is fully charged,

Charge Complete

will replace the

Charging. . .

indicator.

Melody If the handset is off when placed in the docking cradle, it will

charge. A melody is played after the handset is powered on for the
first time following a completed charge (Charge Complete).

Advertising