Philips PD7040/05 - Manual (Page 15)

16
The charge indicator turns on. It takes about 7.0 hours to fully »
charge the battery.
When the battery is fully charged, the charge indicator turns off.
»
Install remote control battery
Caution
Risk of explosion! Keep batteries away from heat, sunshine or fi re. Never discard •
batteries in fi re.
Risk of decreased battery life! Never mix different brands or types of batteries.
•
Risk of product damage! When the remote control is not used for long periods, •
remove the batteries.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
•
equivalent type.
Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/
•
hazardouswaste/perchlorate.
For fi rst-time use:
1 Remove the protective tab to activate the remote control battery.
To replace the remote control battery:
2 Open the battery compartment.
3 Insert 1 CR2025 battery with correct polarity (+/-) as indicated.
4 Close the battery compartment.
EN