Panasonic VDR-D160GN - Manual (Page 95)

Menus
Oth
er
s
95
LSQT1184
∫ [ DISPLAY]
≥ OFF ≥ ON
The screen indications are selected as shown
in the illustration below.
∫ [ POWER SAVE]
≥ OFF ≥ 5 MINUTES
[OFF]:
The power saving function is not activated.
[5 MINUTES]:
When about 5 minutes passed without any
operation, this unit automatically turns off to
prevent the battery from running down. When
you use this unit, turn it on again.
≥ In the following cases, the unit may not turn
off even when you set this to [5 MINUTES].
– When using the AC adaptor
– When connecting the unit to a computer or
printer via the USB cable
∫ [ BEEP SOUND]
≥ OFF ≥ ON
This allows operations such as starting and
ending recording to be signaled by a beep.
When [OFF] is set, no beep is heard when an
operation such as recording is started or
ended.
1 Beep
When you start recording
When you turn on the power
When this unit is recognized by the computer or
the printer, etc.
2 Beeps
When you pause recording
When you turn off the power
2 Beeps for 4 times
When an error occurs e.g. recording not
starting. Check the sentence displayed on the
screen. (l 98)
∫ [ INITIAL SET]
≥ YES ≥ NO
When there is a menu that cannot be selected
depending on a combination of functions, set to
[YES] for changing the menu settings back to
the initial shipping condition.
(Language setting cannot be back to the initial
shipping condition.)
∫ [ DEMO MODE]
≥ OFF ≥ ON
This item is used to start the unit
demonstration.
(Only when using the AC adaptor and the mode
dial is at the
or position)
If you set this to [ON] without inserting a disc or
an SD card, this unit is automatically set to the
demonstration mode for introducing its
functions. If any button is pressed or operated,
the demonstration mode is cancelled. If no
operations take place for approx. 10 minutes,
the demonstration mode automatically starts.
To terminate the demonstration mode, insert a
disc or an SD card, or set this to [OFF]. For
normal use, set this function to [OFF].
∫ [ USB FUNCTION]
≥ PictBridge ≥ PC CONNECT
[PictBridge]:
When you connect the unit to a printer via the
USB cable.
[PC CONNECT]:
When you connect the unit to a computer via
the USB cable.
Setup menu
OFF
ON
;
15:30
15.12.2006
;
R 0h00m
0h00m00s
15:30
15.12.2006
SP
DEMO
LSQT1184(ENG).book 95 ページ ２００７年２月５日 月曜日 午後１時２９分