Precor Total Body 904 - Manual (Page 7)

page 7
Assembling the 904 Total Body Treadmill
Follow the instructions in this section to assemble the 904 Total Body
Treadmill. It is important to read through the entire procedure before assem-
bling your treadmill.
If you do not assemble and use this treadmill according to
the following guidelines, you could void the Precor limited warranty.
Installation Requirements
Follow these installation requirements when installing the treadmill:
• Fill out and mail the limited warranty registration card. The serial
number is written on a label underneath the treadmill on the side beam.
During the assembly process, write the serial number on the limited
warranty card and in this Owner’s Manual (see
Obtaining Service). If you
want a 904 Technical Service Manual, write to:
ATTN: 904 Technical Service Manual
Precor Customer Service Department
P.O. Box 3004
Bothell, WA 98041-3004
• Set up the 904 treadmill on a solid, flat surface. We recommend placing
the treadmill on a low-pile carpet. Do not install the treadmill on hardwood
floors because the wheels might scratch or damage the surface. If the
treadmill is placed on a hardwood floor or a deep-pile carpet, place a piece
of heavy cardboard, plywood, or other flat surface under the unit to
protect the floor or carpet. If the floor is not flat and even, the running belt
may not track properly.
• Locate the treadmill at least 2 feet from walls and furniture. Open space
to the front, sides, and rear of the machine make for a safer mount and
dismount and easier belt adjustment.