ProForm 831.215010 - Manual (Page 5)

5
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench and Phillips
screwdriver .
Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each
drawing is the key number of the part, from the PART LIST on page 22. The number following the key number is
the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in
the parts bag, check to see if it has been pre-assembled. If a part is missing, call toll-free 1-888-533-1333.
M10 x 112mm
Carriage Bolt (43)–4
M8 x 25mm Button
Screw (51)–2
M8 x 90mm Button
Screw (41)–1
M8 x 37mm Button
Bolt (52)–4
M8 Split
Washer (50)–7
M8 Nylon
Locknut (65)–8
M4 x 12mm
Screw (60)–2
M10 Nylon
Locknut (63)–4
M4 x 16mm
Screw (57)–4
1. Attach the Rear Stabilizer (16) to the Frame (1) with
two M10 x 112mm Carriage Bolts (43) and two M10
Nylon Locknuts (63).
63
1
16
1
43