ProForm 831.215010 User Manual
Page 6
6
3
2
42
Make sure that
the wire harness
does not get
pinched and
damaged during
this step.
51
50
1
3. While another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (42) to
the Reed Switch Wire (46). Gently pull the upper end
of the Upper Wire Harness to remove any slack.
Insert the Upright (2) into the Frame (1). Be careful to
avoid pinching the Upper Wire Harness (42) and
the Reed Switch Wire (46). Attach the Upright to the
Frame with two M8 x 25mm Button Screws (51), an
M8 x 90mm Button Screw (41), and three M8 Split
Washers (50).
4. Identify the Left Handlebar (3). Attach the Left
Handlebar to the Upright (2) with two M8 x 37mm
Button Bolts (52) and two M8 Nylon Locknuts (65).
Attach the Right Handlebar (5) to the Upright (2) in the
same way.
3
4
65
52
2
51
50
46
5
2. Orient the Front Stabilizer (15) as shown. Attach the
Front Stabilizer to the Frame (1) with two M10 x
112mm Carriage Bolts (43) and two M10 Nylon
Locknuts (63).
1
2
15
63
43
41