PictureTel LIVELAN 2 - Manual (Page 3)

Category Requirement
Processor A Pentium, Pentium Pro, or Pentium II single processor or equivalent
running at 133-MHz or faster.
PCI Slot One available PCI bus slot for the PictureTel LiveLAN Media
Accelerator Board.
Hard Disk Space
30 MB of available hard disk space for installation.
RAM 32 MB - 256 KB of cache
Operating
System
Microsoft Windows 95 or Windows 98 operating system.
Monitor An SVGA monitor.
Graphics Board
A 32-bit PCI graphics board with 16-bit high color depth and a
minimum of 2-MB of video memory.
Note: Boards with 2D video acceleration and fast video memory, such
as VRAM, are recommended). LiveLAN works best using DirectDraw
and any DirectDraw compatible hardware and driver. For a list of
specific DirectDraw cards that have been tested by PictureTel with
LiveLAN 3.1, refer to the LiveLAN Release Notes and the LiveLAN 3.1
Installation Guide.
Network
Interface Card
(NIC)
A Network Interface Card is required running the Microsoft TCP/IP
stack (Winsock 1.1 or greater).
TCP/IP Protocol
Stack
A WinSock 1.1-compliant TCP/IP protocol stack that supports
Microsoft-specific extensions. (This is the standard TCP/IP stack
delivered with Windows 95.)
If virtual memory is not enabled on your PC, you will not be able to install LiveLAN. To enable virtual
memory on your PC, go to the Windows Control Panel and click the System icon. Choose the Performance tab
and click the Virtual Memory button at the bottom of the tab window. Make sure that the Let Windows manage
my virtual memory settings radio button on the Virtual Memory Dialog box is selected.