PYLE Audio PLTV7.5DIN - Manual (Page 18)

4. WATCHING THE REAR VIEW
Put the gear lever to R(Reverse) on any mode. The monitor will show the rear view camera
picture.
5. WIRING CONNECTION
Connect orange color connection wire with a “REVERSE GEAR” sticker to a switched power
output terminal of the R (Reverse) gear.
See BASIC CONNECTION Part.
NOTE
If you select AV mode connected to the rear view Camera with MODE button, the monitor
does not show the rear view camera picture. The monitor will show only the WARNING
picture.
6. CAMERA ANGLE CONTROL
You should use the car-use rear view camera only, if not the rear view can be displayed with
mirror looking image. Then, you can adjust the image looking correctly as follows.
1) Press MENU button to show CONTROL on the screen.
2) Press SEARCH ▲/▼ button to select CAMERA ANGLE.
3) Press VOLUME ◀ or ▶ button to change CAMERA ANGLE.
Each time you press this button, CAMERA ANGLE will be changed as follows.
0 -> 180
180 : When the image is mirror looking image, you should set the CAMERA ANGLE to 180
in order to watch the rear view with the right looking image.
7. SCREEN ASPECT CONTROL
1) Press MENU button to show CONTROL on the screen.
2) Press SEARCH ▲/▼ button to select SCREEN.
3) Press VOLUME ◀ or ▶ button to change SCREEN aspect.
Each time you press this button, SCREEN will be changed as follows.
NORMAL -> WIDE -> FULL
Refer to the 9. ADJUSTING VIDEO PICTURE MODE of BASIC OPERATION.
18