Polycom IP 430 - Manual (Page 26)


No Response from Feature Key Presses
Verify phone is in active state:
• Make a call to the phone to check
for inbound call display and ring-
ing as normal. If successful, try to
press feature keys within the call to
access Directory or Buddy Status for
example.
Part 15 Rules
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
Safety.and.Compliance
2. This device must accept any interfer-
ences received, including interference
that may cause undesired operation.
Verify LAN cable is properly connected:
• Check termination at the switch or
hub (furthest end of the cable from
the phone).
• Check that the switch or hub is opera-
tional (flashing link/status lights) or
contact your System Administrator.
• Press
Hold
Del
1 3
DEF
5
JKL
4
GHI
6
MNO
8
TUV
7
PQRS
9
WXYZ
0
OPER
* #
2
ABC
Hold
Menu
Messages
Do Not Disturb
ABC 2 1 DEF 3
5 4 MNO JKL GHI 6
TUV 8 7 WXYZ 9
OPER
PQRS
0
Directories
Services
Conference
Transfer
Redial
followed by Status,
Network and Ethernet. Scroll down
to verify LAN port is Active.
• Reboot the phone to attempt recon-
nection to the network.
• Press Menu followed by System Sta-
tus and Server Status to confirm line
is actively registered to the server.
• Reboot the phone to attempt re-reg-
istration to the server.
Display shows “Network Link is Down”
Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential instal-
lation. This equipment generates, uses,
and can radiate radio frequency energy
and, if not installed and used in accor-
dance with the instructions, may cause
harmful interference to radio communica-
tions. However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the interfer-
ence by one or more of the following
measures:
1. Reorient or relocate the receiving
antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experience
radio/TV technician for help.
Class B Digital Device or Peripheral