Pfaff Embroidery Mode-Stitch-Out - Manual (Page 7)

9:7
C D
Embr
oidery mode - stitch-out
To select matching point and rotate design
You have the ability to check a second position
within the design to make sure your design is
lined up properly and make further adjustments if
necessary. Activate (C), matching point.
A second crosshair will appear, the matching point.
Place it at the point where you would like another
part of the design to connect. The hoop will move,
following the matching point.
To line up the design where you want it, activate
(D), rotate design. To move the matching point to
the right place on the fabric, the rotate function will
automatically be selected.
Use the stylus or wheel to rotate the design on the
screen around the locking point, kept in position.
The rotated design will connect with the previously
embroidered design.
Orbiting - to check corners
Orbiting can be used to trace the design fi eld by
touching each of the four corner icons. You can
fi nd the center of the design again by touching the
centering icon.
The orbit function will also swiftly move the
crosshair to the selected position when doing
precise positioning.
Use the corner icons to set the connecting point
for precise positioning in a corner of the design.
This is the easiest and most precise way since
the connecting point will be automatically
placed exactly in the corner. This is useful when
positioning a design on a patterned fabric.
The orbiting icons may be used when either
locking point or matching point is selected. When
touching an orbiting icon, the selected point will
automatically be set to the corresponding orbiting
position, i.e. at a corner or at the center of the
embroidery.
E.g. when choosing the upper left orbiting icon, the
connecting point will be set at the upper left corner
in the outer line of the designs. After this, you can
continue and make your own adjustments on the
connecting point.