Panasonic PT-AE100U - Manual (Page 12)

YPBPR
S-VIDEO
VIDEO
PC
R
AC IN
~
OFF ON
VIDEO IN
PC IN
MAIN
POWER
VIDEO S2 VIDEO
CO
R
AC IN ~
OFF ON
VIDEO IN
PC IN
MAIN
POWER
VIDEO S2 VIDEO
STANDBY(R) ON(G) LAMP TEMP
POWER
KEYSTONE VOLUM INPUT
DIGITAL ZOOM
ENTER
MENU F
MUTE
INPUT ASPECT VOLUME
STANDBY(R) ON(G) LAMP TEMP
POWER
KEYSTONE VOLUM INPUT
DIGITAL ZOOM
ENTER
MENU F
MUTE
INPUT ASPECT VOLUME
Basic
Operation
23 22
Turning off the power
# Hold down the POWER button for at least 0.5 seconds or press the
POWER button twice to turn off the power.
The lamp unit will switch off and the picture will stop being projected. (The
power indicator on the projector will illuminate orange.)
$ Wait until the power indicator on the projector illuminates red (until
the cooling fan stops).
Do not in any way cut power to the projector while the cooling fan is still
operating. Be careful not to switch off the MAIN POWER switch of the
projector, unplug the power cord from the electrical outlet or turn off in-line
switches such as tabletop power switches.
% Press the MAIN POWER switch to the “O” side to turn off the power.
NOTE:
B After the power is turned off, the lamp unit will take some time to cool
down. If you turn the power back on again before the lamp unit has cooled
down, the lamp unit may not turn on straight away, but it will turn on
automatically after a short period. (During this time, the power indicator on
the projector will flash orange.)
B When the projector is in standby mode (the power indicator on the
projector is illuminated red), the projector will still draw a maximum 0.7 W
of power, even when the cooling fan has stopped.
B If the MAIN POWER switch is accidentally turned off while the projector is
being used, the lamp unit may not turn on straight away after the power is
turned back on. In such cases, the lamp unit will turn back on
automatically after a short period. (During this time, the power indicator on
the projector will flash green.)
B A tinkling sound may be heard while the power indicator is turned off, but
this is not a sign of a malfunction.
Starting to use
Turning on the power
Please ensure that all preparations have been completed before turning on
the power. (Refer to pages 18 – 21.)
# Remove the lens cover.
$ Connect the accessory power cord.
% Press the MAIN POWER switch to
the “|” side to turn on the power.
The power indicator on the projector
will illuminate red.
& Press the POWER button.
The power indicator on the projector
will flash green. After a short period,
the button will illuminate green, and a
picture will be projected.
' Turn on the power of all connected
devices.
Start the Play function a device such
as a DVD player.
( Press the INPUT select button to
select the input signal.
The input signal selected will change
as shown at below-right each time an
input select button is pressed.
Zoom
Focus
) While pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector.
If there is keystone distortion in the
projected images, carry out keystone
correction as described on page 29.
* Turn the focus/zoom ring to adjust
the projected image focus and size.