Panasonic SC-ZT2 - Manual (Page 25)

VQT2R70
25
Troubleshooting and
other information
Error messages/Using with headphones/Speci
fi cations
Error messages
Display Check point/Cause/Countermeasure Pages
CANCEL MUTE FUNCTION (Scrolling) • The test signal is not output while muting is on. Cancel muting for operation. 20
MUTE (Blinking) • This is always displayed while muting is on. 20
NOT POSSIBLE FOR
THIS INPUT SOURCE (Scrolling) • You cannot use Dolby Virtual Speaker, SFC and Dolby Pro Logic for dual
sounds.
—
NOT POSSIBLE FOR
THIS PCM SOURCE (Scrolling) • You cannot use Dolby Virtual Speaker, SFC and Dolby Pro Logic effect with
PCM signals with sampling frequency of over 48 kHz.
17
NOT POSSIBLE WHEN USING
HEADPHONES (Scrolling)
• You cannot use the sound field effects when using headphones. 25
REMOTE 2
REMOTE 1
• Set the same remote control code for this main unit and remote control. When “ REMOTE 2 ”
is displayed, set the code to “ 2 ” on the remote control in step 4 of procedure “When other
equipment (mini component system, AV amp, etc.) manufactured by Panasonic operates
with the remote control operations of this system”. When “
REMOTE 1 ” is displayed, set the
code to “ 1 ” on the remote control in step 4 in the same way.
24
SWITCH OFF POWER
(Scrolling) • While “ F70 ” is displayed, all operations but turning ON/OFF operation are not
available. Turn off the system, unplug the AC power supply cord, and consult your dealer.
—
TURN OFF DTS FIX MODE
(Scrolling) • When each input is fixed to DTS (DTS FIX), the sound field effects cannot be
canceled even if you press [–SETUP, OFF]. Cancel DTS FIX.
24
U701 • The equipment connected by the HDMI cable is not compatible with this system’s copyright protection technology. —
U703
• A problem has occurred with the HDMI connection. Try the following to correct
the problem. Consult your dealer if the error code remains on the display.
– Turn the connected equipment off and on again.
– Disconnect the HDMI cable then reconnect it.
– Do not connect more than 2 sets of equipment to this system’s output.
—
U704
• The system received incompatible video signals through HDMI connection.
Check the settings of the connected equipment.
—
Specifi cations
Using with headphones
Note
• Avoid listening for prolonged periods of time to prevent hearing
damage.
• Multi-channel signals are forcibly converged to 2-channel and
output. (2CH MIX)
However, for DVD audio, the front left and right signals are output.
Turn down the volume closest to the minimum value.
• Plug type: ø 3.5 mm (1/8 in.) stereo mini plug
g PRE AMPLIFIER SECTION
Input sensitivity / Input impedance
TV, AUX3 600 mV / 47 k Ω
S/N ratio (IHF A)
BD/DVD, TV, AUX1,
AUX2 (Digital Input)
80 dB (IHF '66)
Tone controls
BASS 50 Hz, + 6 to –6 dB
TREBLE 20 kHz, + 6 to – 6 dB
Input/Output terminal
Audio Input
Analog Input ( TV, AUX3 ) 2
Optical Digital Input ( TV, AUX2 ) 2
Audio Output
Audio Output ( Front L/R, Surround L/R ) 4
Subwoofer Output 1
Headphone Output ( 16 to 64 Ω ) 1
Video/Audio
HDMI Input ( BD/DVD, AUX1 ) 2
HDMI Output ( TO TV (ARC)) 1
This system supports “HDAVI Control 4” function.
g MAIN UNIT GENERAL
Power supply AC 120 V, 60 Hz
Power consumption 16 W
In standby condition 0.5 W
In standby condition ( HDMI off mode ) 0.2 W
Dimensions ( W x H x D ) 430 mm x 59 mm x 262 mm
(16-15/16" x 2-5/16" x 10-5/16")
Mass [ Weight ] Approx. 2 kg (4.4 lb.)
Operating temperature range 0°C to 40 °C (32°F to 104 °F)
Operating humidity range 20 % to 80 % RH (no condensation)
g WIRELESS SECTION
Frequency of the using band 2.4000 GHz to 2.4835 GHz
Number of using channels 3
The reaching distance 15 m (49 ft) ∗1
∗1 It is under the condition as follows.
At same room indoor, there is not an obstacle
between the main unit and the speaker.
And installing a main unit in the position with
equal to or more than 50 cm height.
SPEAKER
g POWER AMPLIFIER SECTION ∗2
RMS output power
10 % total harmonic distortion
Woofer Speaker ch 60 W (100 Hz, 3 Ω)
Mid High Speaker ch 20 W (1 kHz, 8 Ω)
System Total Power ∗3 160 W (80 W x 2)
FTC output power
1.0 % total harmonic distortion
50 Hz to 250 Hz Woofer Speaker ch 37 W (3 Ω)
250 Hz to 20 kHz Mid High Speaker ch 13 W (8 Ω)
System Total Power ∗3 100 W (50 W x 2)
g SPEAKER SECTION ∗2
2-way 5 speakers system (Bass reflex type)
Woofer part 12 cm cone type x 1
Mid High part 2.4 x 10 cm flat type x 4
g SPEAKER GENERAL ∗2
Power supply AC 120 V, 60 Hz
Power consumption 20 W
Wireless Link Standby 0.8 W
In Standby condition 0.1 W
Dimensions ( W x H x D ) 290 mm x 1231 mm x 290 mm
(11-13/32" x 48-15/32" x 11-13/32")
Mass [ Weight ] Approx. 3.9 kg (8.6 lb.)
Operating temperature range 0°C to 40°C (32°F to 104°F)
Operating humidity range
20 % to 80 % RH (no condensation)
∗2: per 1 speaker
∗3: use 2 speakers
Note: 1. Specifications are subject to change
without notice.
2. Total harmonic distortion is measured by
the digital spectrum analyzer.
3. Total harmonic distortion is measured by
using AES17 filter.
MAIN UNIT
W (Headphone) jack
Headphones
(not included)
5%<622
8364 'PKPFF 5%<622
8364 'PKPFF ඦ೨   ඦ೨