Philips CCC 193AT - Manual (Page 52)

POWER
EJECT
SPEED
MEMORY
1 2 3
4 5 6
7 8 9
0
CH. VOL.
SLEEP/
WAKE UP ALT.CH
REW
PLAY
F.FWD
REC
/OTR
PAUSE
/STILL
STOP
MUTE
TRACKING
FM
F.ADV
SLOW
MENU STATUS/EXIT CLEAR
52 FM Radio
1
Press the FM button to select FM mode. The radio frequency
appears on the TV/VCR screen, moving around the screen every few
seconds.
2
Press the CH(annel) o o// /p p buttons until your desired radio
frequency appears. You can choose FM stations within the band
range of 88.0 ~ 108.0 MHz. You may get better FM reception by
repositioning the TV/VCR.
3
To exit FM mode and return to TV mode, press the FM
button again.
• If you turn off the TV/VCR in FM
mode, the TV/VCR will be in TV
mode when you turn on the TV/VCR
again.
• You cannot record the FM station.
• You cannot switch to FM mode dur-
ing tape playback, although tape
playback is allowed while in FM
mode.
• You must be in TV mode in order to
select Line Input mode (A/V IN).
Helpful Hints
Follow the steps below to listen to FM radio stations through the
TV/VCR.
FM 88.0MHz
2
1,3
Switching the Antennas
If you receive a weak radio signal, you may go to TV mode and
switch between the internal (INT) and external (EXT) antennas.
When you select the external antenna, make sure your TV antenna
or TV cable signal is connected to the ANT(enna) Jack on the
TV/VCR. Details are on page six.
To switch the antennas, follow these steps.
1
Press the FM button to return to TV mode if necessary.
2
Press the MENU button.
3
Press the PLAY/▲ button or the STOP/▼ button to select FM
ANTENNA.
4
Press the REW(ind)/{ button or the F.FWD/B button to select
INT or EXT.
5
Press the STATUS/EXIT button.
Choosing FM stations...