Philips ISP1301 - Manual (Page 8)

Philips Semiconductors ISP1301 USB OTG Transceiver Eval Kit User’s Guide
UM10028_1 © Koninklijke Philips Electronics N.V. 2003. All rights reserved.
User’s Guide Rev. 1.0—February 2003 8 of 18
J13
U1
J9
J3
J1
J4
J10
J8
U4
J11
J6 J7
J
5
J 2
J12
JP6
JP4 JP3
JP1
JP5 JP2
ISP1301 EVALUATION BOARD
REV 1.0
SW1
Figure 4-1: Location of major components
5. Test program 1301.EXE
5.1. Introduction
A DOS test program “1301.exe” is provided to help you verify the functions of the ISP1301 chip. The program
uses the PC parallel port to access the ISP1301 registers through the I
2 C interface. The program simulates
software I 2 C master at the hardware abstraction layer (HAL).
The test program can do the following:
•
Set the I 2 C slave address for the ISP1301 based on the hardware setting of the ADR pin
•
Reset all registers to their default values
•
Display the current value of all registers on your PC screen
•
Write any value to a writable register
•
Set the mode of operation of the ISP1301 (such as, USB function and suspend mode, transparent I 2 C
mode, transparent general-purpose buffer mode, and global power-down mode)
•
Enable or disable the charge pump of the ISP1301.