Panasonic AG-AC160AEN - Manual (Page 32)

32
SIMUL REC
When memory cards are inserted in both of the two slots, activating this function enables recording the
same video to both the memory cards. Set the [SIMUL REC] item on the setup menu [RECORDING
SETUP] screen to [ON] to enter the SIMUL REC mode.
In the media capacity display on the screen, the available recording time possible for SIMUL REC (the
available recording time of the memory card with lower memory capacity) is displayed, and the icon
[
] is displayed.
• Recording stops when one of the memory cards in Slot 1 or Slot 2 has no remaining space.
(The following figure shows the case that the memory card in Slot 1 becomes full.)
Slot 1
Slot 2
Clip A
Clip A
Standby
Standby Standby
Clip B
Clip B
If you press the <START/STOP> button without replacing the memory card in Slot
1, video will be recorded normally on the memory card in Slot 2 (the memory card
with remaining memory).
When the capacity of Slot 1 (the memory card with
lower remaining memory) becomes full, SIMUL REC
will stop.
To resume the SIMUL REC, replace the memory card
to a new memory card and press the
<START/STOP> button.
Start
recording
End recording
Start
recording
Clip C
Stop recording
(No space left on memory card)
Memory card recording time
Start recording(normal recording)
• If the remaining capacity of the memory card in Slot 1 is same as in Slot 2, the remaining capacity in
Slot 1 is displayed.
• SIMUL REC cannot be used at the same time as relay recording, VFR recording, or INTERVAL REC.
• During SIMUL REC, if recording has stopped because a recording error has occurred in one of the
memory cards, the other memory card will continue to record.
• After SIMUL REC ends, when there is capacity remaining on one of the memory cards, that memory
card will automatically be selected as the memory card for recording. Press the <START/STOP>
button again for normal recording.
• While in SIMUL REC mode, if only one memory card is inserted, normal recording takes place.
• After SIMUL REC, the REC CHECK function does not operate.
• After SIMUL REC, the [LAST CLIP] function does not operate.
• When switching to <PB> mode after SIMUL REC, the thumbnails of the memory card in slot 1 will be
displayed.