Panasonic AG-AC160AEN - Manual (Page 42)

42
Using an external microphone and
audio devices
INPUT1 switch
(MIC POWER +48V)
INPUT2 switch
(MIC POWER +48V)
INPUT1 LINE/MIC switch
INPUT2 LINE/MIC switch
AUDIO INPUT1 terminal
(XLR 3-pin)
AUDIO INPUT2 terminal
(XLR 3-pin)
1
Connect an external microphone or audio
device to the AUDIO INPUT1/2 terminals (XLR
3-pin). (Page 67)
2
Switch the connected audio input signal
with the INPUT1 LINE/MIC switch or INPUT2
LINE/MIC switch.
<LINE>: (When connecting audio device)
The input level is 0 dBu.
<MIC>: (When connecting an external
microphone)
The factory setting for input level is -50 dBu.
The input level can be changed to [-40dB] or
[-60dB] with the [MIC GAIN1] item and [MIC
GAIN2] item on the setup menu [RECORDING
SETUP] screen. (Page 90) However, sensitivity
will be higher when set to [-60dB], and more
noise may be recorded.
3
When using the phantom microphone (which
requires +48V power supply)
Set the INPUT1 switch (MIC POWER+48V) and
INPUT2 switch (MIC POWER+48V) to <ON>.
<ON>: (When connecting the phantom
microphone)
+48V power is supplied to AUDIO INPUT1/2
terminals.
<OFF>: (When not connecting the phantom
microphone)
+48V power is not supplied to AUDIO
INPUT1/2 terminals.
• When you use a phantom microphone, the
battery duration will become shorter.
• When devices that do not support +48V
power supply are connected, set the phantom
microphone to <OFF>. If set to <ON>, the
connected devices might be damaged.
• When using the AG-MC200G (optional), set
the [MIC GAIN1] or [MIC GAIN2] item of the
[RECORDING SETUP] screen to [-50dB].
4
Use the AUDIO CH1 SELECT switch to select
the input signal to be recorded to audio
channel 1.
<INT (L)>:
Audio from the built-in microphone Lch is
recorded.
<INPUT1>:
Audio from the device connected to AUDIO
INPUT1 terminal is recorded.
<INPUT2>:
Audio from the device connected to AUDIO
INPUT2 terminal is recorded.
5
Use the AUDIO CH2 SELECT switch to select
the input signal to be recorded to audio
channel 2.
<INT (R)>:
Audio from the built-in microphone Rch is
recorded.
<INPUT2>:
Audio from the device connected to AUDIO
INPUT2 terminal is recorded.