Charging the built-in battery, Setting the time code, Specifying the time code ([tcp reset] item) – Panasonic AG-AC160AEN User Manual

Page 51: Charging the built-in battery/setting the time, Code, Item)

Advertising
background image

51

Shooting

Charging the built-in battery/setting the time code

Charging the built-in battery

The camera uses the built-in battery to remember
the date and time.
If [LOW INTERNAL BATTERY] (built-in battery level
is low) is displayed when the date and time are
set, it means that the built-in battery is depleted.
Charge the battery with the following method.
Set the date and time after the battery fully
charged.

1

Connect an AC adaptor to the camera.

(Page 27 of Vol.1)

•

Leave the POWER/MODE switch of the
camera at <OFF>.

2

Leave the camera for approximately four

hours.

•

The built-in battery is charged.

•

Check the time code and menu operations
after charging.

If the date and time are not remembered after
charging, the built-in battery needs to be replaced.
Consult your dealer.

Setting the time code

Perform various time code related settings with the
following items on the setup menu [TC/UB SETUP]
screen. (Page 91)

•

[TC MODE] item

•

[TCG] item

•

[TC PRESET] item

•

[UB MODE] item (DV mode only)

Specifying the time code ([TC

PRESET] item)

Set the time code value with the [TC PRESET]
item to record any value as the time code value at
the start of recording.

1

Turn the POWER/MODE switch of the

camera <ON>. (Page 30 of Vol.1)

2

Select the [TC PRESET] item on the setup

menu [TC/UB SETUP] screen.

•

Menu operation (Page 31 of Vol.1)

•

Operations can be performed with buttons on
the remote control that correspond to those on
the camera. For details, see “Remote control”
(Page 24 of Vol.1).

3

Tilt the OPERATION lever in the < >

direction to move to [YES], and push the

OPERATION lever.

Advertising
This manual is related to the following products: