Standards compliance for snmp traps, Snmp traps, Warmstart – Paradyne 8784 User Manual
Page 93: Authenticationfailure, B standards compliance for snmp traps, Appendix b, Standards, Compliance for snmp traps, R to, Appendix b, standards compliance for snmp traps
Advertising
8784-A2-GB20-30
February 2001
B-1
B
Standards Compliance for SNMP Traps
SNMP Traps
This section describes the unit's compliance with SNMP standards and any
special operational features for the SNMP traps supported. The unit supports the
following traps:
T
T
T
warmStart
authenticationFailure
SNMP Trap
Description
Possible Cause
warmStart
The unit has reinitialized
itself.
The trap is sent after the unit
resets and stabilizes.
There are no
variable-bindings.
T
Reset command.
T
Power disruption.
SNMP Trap
Description
Possible Cause
authenticationFailure
Failed attempts to access the
unit.
There are no
variable-bindings.
Three unsuccessful attempts
were made to enter a correct
login/password combination.
Advertising