Pride Mobility Jazzy Select 14 - Manual (Page 22)

22 www.pridemobility.com Jazzy Select 14 Series
I V . A S S E M B L Y
Seat Installation
It may be necessary to install the seat either prior to initial
operation or after transporting your power chair.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat:
1. Set the seat on the seat tower. See figure 10.
2. Push the seat down until the latch engages.
3. Install the controller and route the cable to the rear of
the power base. See figure 11.
4. Plug the controller connector into the power base. See
figure 6.
5. Secure the controller cable to the armrest receiver with
wire ties.
Figure 10. Seat Installation
SEAT
TOWER
Figure 11. Cable Routing