Philips XA311 - Manual (Page 25)

25
75 ⍀
VIDEO
L/
Mono
AUDIO
R
Monitor out AV1 in
S-VIDEO
75 ⍀
VIDEO L/ Mono AUDIO R
Monitor out AV1 in
S-VIDEO
VOL
ANTENNA
OUT
ANTENNA
IN VIDEO AUDIO
IN IN
OUT OUT
L R
3
1
2
4
5
6
S-VHS OUT
U
SING THE
S-V
IDEO
I
NPUT
J
ACKS
T he S(uper)-Video connection on the
rear of the TV can provide you with
better picture detail and clarity for the
playback of accessory sources such as
DBS (digital broadcast satellite), DVD
(digital video discs), video games, and
S-VHS VCR (video cassette recorder)
tapes than the normal antenna picture
connections.
NOTE: The accessory device must
have an S-VIDEO OUT(put) jack in
order for you to complete the connec-
tion on this page.
Connect one end of the S-VIDEO
CABLE to the S-VIDEO jack on the
back of the TV. Then connect one end
the AUDIO (red and white) CABLES
to the AV1 in AUDIO L and R(left and
right) jacks on the rear of the TV.
Connect other end of the S-
VIDEO CABLE to the S-VHS (S-
Video) OUT jack on the back of the
VCR. Then connect the other ends of
the AUDIO (red and white) CABLES
to the AUDIO (left and right) OUT
jacks on the rear of the VCR.
Turn the VCR and the TV ON.
Press the CH + or – buttons on the
remote to scroll the channels until
SVHS appears in the upper left corner
of the TV screen.
Slide the TV/VCR/ACC switch to
the VCR position.
Now your ready to place a prere-
corded video tape in the VCR and
press the PLAY ᮣ button.
AUDIO IN
(RED/WHITE)
VCR EQUIPPED WITH
S-VHS (S-Video) JACKS
S-VIDEO
CABLE
BACK OF VCR
BACK OF TV
IF YOU ARE USING A MONO
DEVICE, USE ONLY THE
AUDIO L/MONO JACK.
The S-VIDEO and VIDEO
AV1 in(puts) are in parallel. The
S-VIDEO input is dominant when in
use. If separate video signals are con-
nected to the S-VIDEO and VIDEO
AV1 in(puts), the signal from the
VIDEO AV1 in(put) will not be usable.
S MART H ELP
Note: SVHS will appear as a valid
channel option only if a S-Video
device is connected to the S-Video
Input. If no device is connected to
the S-Video Input, the channel will
appear as AV1.
SVHS