Philips BDP2900 User Manual

Page 20

Advertising
background image

20

EN

5LVN RI LQMXU\ RU GDPDJH WR WKH SURGXFW
‡

Visible and invisible laser radiation when
open. Avoid exposure to beam.

‡

Do not touch the disc optical lens inside
the disc compartment.

‡

1HYHU SODFH WKH SURGXFW RU DQ\ REMHFWV
on power cords or on other electrical
equipment.

‡

If the product is transported in
temperatures below 5°C, unpack the
product and wait until its temperature
matches room temperature before
connecting it to the power outlet.

5LVN RI RYHUKHDWLQJ
‡

1HYHU LQVWDOO WKLV SURGXFW LQ D FRQÀQHG
space. Always leave a space of at least four
inches around the product for ventilation.
0DNH VXUH WKDW FXUWDLQV RU RWKHU REMHFWV
never cover the ventilation slots on the
product.

5LVN RI FRQWDPLQDWLRQ
‡

Do not mix batteries (old and new or
carbon and alkaline, etc.).

‡

Remove batteries if they are exhausted or
if the remote control is not to be used for
a long time.

‡

Batteries contain chemical substances, they
should be disposed of properly.

5LVN RI VZDOORZLQJ EDWWHULHV
‡

The product/remote control may contain a
coin type battery, which can be swallowed.

‡

Keep the battery out of reach of children
at all times!

CLASS 1

LASER PRODUCT

Important notes for users in
the U.K.

Mains fuse
This information applies only to products with a
UK mains plug.
7KLV SURGXFW LV ÀWWHG ZLWK DQ DSSURYHG QRQ
molded plug. If you replace the fuse, use one
with:
‡

the ratings shown on the plug,

‡

a BS 1362 approval, and

‡

the ASTA approval mark.

Contact your dealer if you are not sure about
what type of fuse to use.
Caution: To conform with the EMC directive
(2004/108/EC), do not detach the plug from
the power cord.

How to connect a plug
The wires in the power cord are colored as
follows: blue = neutral (N), brown = live (L).
If the colors do not correspond with the colors
on your plug, identify the terminals in your plug
as follows:

1

Connect the blue wire to the terminal
marked N or colored black.

2

Connect the brown wire to the terminal
marked L or colored red.

3

Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
colored green (or green and yellow).

Before you replace the plug cover, make sure
that the cord grip is clamped over the sheath
RI WKH FDEOH DQG QRW MXVW RYHU WKH WZR ZLUHV LQ
the cable.

Copyright in the U.K.
‡

Recording and playback of material may
require consent. See Copyright Act 1956
and The Performer’s Protection Acts 1958
to 1972.

Advertising
This manual is related to the following products: