ProForm PFBE1144.0 - Manual (Page 5)

5
1.
Press two Stabilizer Endcaps (17) onto the Front
Stabilizer (4).
Attach the Front Stabilizer (4) to the Front Frame
(1) with two M8 x 70mm Button Bolts (25), two
M8 Washers (34), and two M8 Nylon Locknuts
(31). Do not tighten the Locknuts yet.
2. Press two Stabilizer Endcaps (17) onto the Rear
Stabilizer (3).
Attach the Rear Stabilizer (3) to the Rear Frame
(2) with two M8 x 70mm Button Bolts (25), two
M8 Washers (34), and two M8 Nylon Locknuts
(31).
Tighten the M8 Nylon Locknuts (31) used in
steps 1 and 2.
Before beginning, make sure you under-
stand the information in the box above.
Note: Some parts described in the assem-
bly steps may be pre-assembled.
ASSEMBLY
25
25 4
31
34
17
17
34
1
2
34
34
3 25
25
2
31
1
As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
The following tools (not included) may be
required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Clear tape or masking tape, and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. Most people find that by
setting aside plenty of time, assembly will go
smoothly.
17
17