Philips MCM710 - Manual (Page 16)

16
English
CD/MP3-CD Operation
To find a passage within a track
1
Press and hold the control knob on the front
panel to the left or right (corresponding to
S / T ) or press
5 /6
on the remote.
2
When you recognize the passage you want,
release the control knob (
5 /6
on the
remote).
➜
Normal playback continues.
To stop playback
●
Press
9.
To interrupt playback
● Press ÉÅ during playback.
➜ The display freezes and the elapsed playing
time flashes when playback is interrupted.
➜ To resume, press ÉÅ again.
Notes:
CD play will also stop when;
– the CD door is opened.
– the disc has reached the end.
– you select another source: FM, USB or AUX.
– you select standby.
– the set auto off time arrives.
To scan all tracks in a disc
● Press INTRO on the remote to play the first
10 seconds of each track in the whole disc one
by one.
➜ INTRO appears on the display.
➜ The playback will start from the first track of
the current disc.
To stop scanning
● Press INTRO on the remote again until
INTRO disappears.
Playing an MP3 disc
1
Load an MP3 disc.
➜
The disc reading time may exceed 10
seconds due to the large number of songs
compiled into one disc.
2
Press ALBUM +/- on the remote to select a
desired album.
3
Press the control knob on the front panel to the
left or right (corresponding to
S / T ) or
press ¡ / ™ on the remote to select a desired
track.
➜ The album number will change accordingly as
you reach the first track of an album by pressing
S (
¡ on the remote) or the last track of an
album by pressing T ( ™ on the remote).
4
Press ÉÅ to start playback.
Supported MP3 disc formats:
– ISO9660, Joliet
– Maximum title number: 512 (depending on
filename length)
– Maximum album number: 255
– Supported sampling frequencies: 32 kHz,
44.1kHz, 48 kHz
– Supported Bit-rates: 32~256 (kbps), variable
bitrates
pg001-025_MCM710_12-Eng 2007.12.7, 10:42 16