Philips MCM710 - Manual (Page 22)

22
English
Clock/Timer
Setting the clock
1
In Standby mode, press and hold CLOCK on
the remote until the time flashes on the display.
➜
”
CLOCK SET ” is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
hours.
3
Press CLOCK to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
minutes.
5
Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
Viewing the clock
●
Press CLOCK in the active mode.
➜
The clock time is displayed.
Setting the timer
●
The system can be used as an alarm clock,
whereby the CD, USB, FM, AUX is switched on
at a set time. The clock time needs to be set first
before the timer can be used.
●
During setting, if no button is pressed within 30
seconds, the system will exit timer setting mode
automatically.
1
Press and hold TIMER on the remote control
until the time flashes on the display.
➜ ” TIMER SET” is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
hours.
3
Press TIMER to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
minutes.
5
Press TIMER to confirm the time setting.
➜
”
OFF” flashes on the display screen.
6
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to select
“ON”.
➜
icon appears on the display screen.
To deactivate the timer
● Select “OFF” at Step 6.
Activating and deactivating
SLEEP
The sleep timer enables the system to switch off
by itself after a set period of time.
●
Press SLEEP on the remote control.
➜ The display shows one of the sleep time
options in the following sequence:
SLEEP-00,
SLEEP-10, SLEEP-20, ... SLEEP-90,
SLEEP-00... Once the sleep funtion is
activated, the
SLEEP icon will be displayed.
●
To deactivate, press SLEEP on the remote
control once or more until OFF is shown, or
press STANDBY-ON/ ECO POWER B
(
or B on the remote).
➜ SLEEP disappears.
pg001-025_MCM710_12-Eng 2007.12.7, 10:42 22