Philips SCD496 - Manual (Page 9)

Features
adjusting loudspeaker volume
1 Briefly press the volume + and – buttons on the baby unit until the desired loudspeaker
volume for the baby unit has been reached (Fig. 15).
 Briefly press the volume + and – buttons on the parent unit until the desired loudspeaker
volume for the parent unit has been reached (Fig. 16).
Note: If you press the volume + and – buttons too long, the volume is not adjusted.
Note: You only have to adjust the baby unit volume when you use the talk function (see below).
Note :If the volume is set to a high level, the units consume more power.
talk function
You can use the TALK button on the parent unit to talk to your baby (e.g. to comfort your baby).
1 Press and hold the TALK button and talk clearly into the microphone (Fig. 17).
 Release the TALK button when you have finished talking.
Note: When you press the TALK button, you can no longer hear your baby.
adjusting microphone sensitivity
You can set the microphone sensitivity of the baby unit to the desired level. You can only change the
microphone sensitivity when a connection between the baby unit and the parent unit has been
established, i.e. when the LINK light on the parent unit lights up green continuously.
1 Briefly press the SENSITIVITY button on the parent unit (Fig. 18).
The sound level lights on the parent unit light up for approx.  seconds to indicate
the current sensitivity level.
 Briefly press the volume + and - buttons on the parent unit until the desired microphone
sensitivity level for the baby unit has been reached.
Note: If you press the SENSITIVITY button and/or the volume + and – buttons too long, the sensitivity is
not adjusted.
one light on = minimum sensitivity level
all lights on = maximum sensitivity level
Note:When the microphone sensitivity of the baby unit is set to a high level, it picks up more sounds and
therefore transmits more often. As a result, the units consume more power.
Silent baby monitoring
1 Briefly press the volume down (–) button on the parent unit until the volume is switched off
completely (Fig. 19).
The volume is completely switched off when all sound level lights are out.
As long as the baby unit does not detect a sound, all sound level lights on the parent unit are
out (Fig. 0).
When the baby unit picks up a sound, one or more sound level lights on the parent unit
come on. The louder the sound, the more lights come on.
paging the parent unit
If you have misplaced the parent unit and its volume is switched off, you can use the PAGE button
on the baby unit to locate the parent unit.
1 Briefly press the PAGE button on the baby unit (Fig. 21).
,
,
,
,
,
EngliSh 9