Cleaning and sanitizing your pump, Disassembling your electronic pump – Philips SCF304/02 User Manual

Page 4

Advertising
background image

Clean with a Damp Cloth when Necessary:

Control handle (a)

Tubing (i/j/k)

Note: The tubes are used for
suction and do not carry milk.

Double pumping connector (l)

Pump motor (m)

Caution: NEVER put the control handle or pump motor in water or a sterilizer, as you can cause permanent
damage to the pump.

Clean Before Every Use (including first use):

Silicone diaphragm (b)

White valve (c)

Pump body (d)

Milk container (e)

Let-down Massage Cushion (g)

Funnel cover/White stand (h/f)

Cleaning Instructions:

These pump parts should be sanitized before every use.

Disassemble the pump before cleaning. Wash in warm soapy

water and rinse, or wash on the top rack dishwasher. Sanitize

in a steam sterilizer (electronic or microwave) or by boiling

in water for 5 minutes.

Caution: Do not use antibacterial or abrasive cleaners/detergents. To clean the valve, rub gently
between your fingers in warm soapy water – do not insert objects as this may cause damage.

HELPFUL TIP!

The Philips AVENT Electronic and Microwave

Steam Sterilizers are designed to hold the

washable components of the Electronic Breat

Pump and the entire Manual Breast Pump.

6

Need Help? Call us at 1.800.54.AVENT or visit www.philips.com/AVENT

a

c

d

e

g

h

i

l

m

b

f

j k

Make sure that your breast pump is turned off and unplugged before cleaning.

Cleaning and Sanitizing Your Pump

2

5

4

3

5

Make sure that your breast pump motor is turned off and unplugged before disassembling parts.
See section titled, ‘Twin Electronic Breast Pump Parts Guide’ on page 1 for a description of the First
(Control) Pump and Second Pump.

Second Pump

On the second pump, detach the transparent tube

from the double pumping connector. Remove the

double pumping connector by pulling it away from

the silicone diaphragm.

Remove the Let-down Massage Cushion

by gently pulling it away from the funnel

on the pump body.

Remove the white valve from the pump body.

Remove the silicone diaphragm by pulling it

away from the pump body.

Perform steps 3-5 on both the First
(Control Pump) and Second Pump.

1

First (Control) Pump

On the first (control) pump, remove the control

handle by pulling it away from the silicone diaphragm.

First (Control) Pump

Second Pump

Disassembling Your Electronic Pump

Advertising
This manual is related to the following products: