Philips WAS7500 User Manual
Page 91
Frequently asked questions
87
ENGLISH
Problem
Solution
Nothing appears on the synchronous
display of the 2-way remote control
of
even after the set is switched
on.
You have switched on the set with the
y
button on
the set and not the
y
button on the 2-way remote
control. Press
REFRESH
on center’s 2-way remote
control to synchronize its display.
The remote control does not
function properly.
• Reduce the distance between the remote control
and the set.
• Insert the batteries with correct polarity (+/- as
indicated inside the compartment).
• Replace the batteries.
• Point the remote control directly towards the IR
sensor.
The screen of
is stuck in a menu
or shows no response for a long
period of time (2-5 minutes).
Please first try to press
y
to go to power-saving mode.
If the problem persists, restart the power (disconnect
and reconnect the mains plug) to reset
.
‘No Disc’ / ‘Cannot read CD’ is
displayed.
• Insert a suitable disc.
• Check if the disc is inserted with the graphics side
(label) facing you.
• Wait for the moisture condensation on the lens to
clear.
• Replace or clean the disc, see 1.5 Maintenance.
• Use a finalized CD-RW or CD-R.
Sound cannot be heard or is of poor
quality.
• Adjust the volume.
• Disconnect the headphones.
• Switch off MUTE.
The disc skips tracks.
• Replace or clean disc.
• Switch off SHUFFLE.
Sound skips during MP3/WMA
playback.
• The MP3/WMA file may be made at a compression
level exceeding 320kbps. Use a lower compression
level to rip audio CD tracks.
• Replace or clean disc.