Pride Mobility Jazzy 600 XL - Manual (Page 24)

24 www.pridemobility.com Jazzy 600 XL
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest
receiver bracket. See figure 16.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
See figure 16.
2. Loosen the jam nuts.
3. Turn the adjusting screw clockwise to lower the front of the
armrest, or turn the adjusting screw counterclockwise to raise
the front of the armrest.
4. Tighten the jam nuts to lock the adjusting screw into place.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different heights
in 1/2-in. increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot platform
bracket. See figure 17.
2. Loosen the foot platform securement nut one-half turn.
3. Raise or lower the foot platform to the desired height.
4. Reinstall the quick release fasteners into the foot platform
bracket and tighten.
5. Tighten the securement nut.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot platform
bracket. See figure 17.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the quick release fasteners into the foot platform
bracket and tighten.
Quick Release Fasteners: The foot platform is attached to
the power base with two quick release fasteners. See figure
17. Each quick release fastener consists of a bolt, a lever, and
a nut. See figure 18. The lever has a cam on the end that
allows it to clamp into place. The quick release fastener has
V . C O M F O R T A D J U S T M E N T S
Figure 17. Foot Platform Adjustment
FOOT
PLATFORM
BRACKET
FOOT PLATFORM
RETAINING PIN
QUICK RELEASE
FASTENERS
Figure 18. Quick Release Fastener Operation
LEVER (OPEN)
BOLT
NUT
CAM
UNCLAMPED CLAMPED
LEVER (FULLY CLOSED)
SETSCREW
SECUREMENT
NUT
JAM NUT