Pride Mobility Jazzy 600 XL User Manual

Page 37

Advertising
background image

Jazzy 600 XL

www.pridemobility.com

37

V I I I . C A R E A N D M A I N T E N A N C E

WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be

damaged.

Cleaning Instructions

WARNING! Never hose off your power chair or place it in direct contact with water. Your power chair

has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.

WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become

slippery or dry out and crack. Use soapy water and dry the seat thoroughly.

Tire/Wheel Replacement

If you have pneumatic tires and you have a flat tire, you can replace the tube. If your chair is equipped with a solid tire
insert, then you must replace the entire wheel assembly. Replacement tires, tubes, and wheel assemblies are readily avail-
able through your authorized Pride Provider.

WARNING! To avoid possible injury, be sure that the controller’s power is turned off and the

power chair is not in freewheel mode before performing this procedure.

WARNING! Completely deflate the tire before attempting repair.

Follow these easy steps for a quick and safe repair for both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tire, completely deflate it before removing the wheel.
4. Remove the drive wheel nut and washer from the wheel hub. See figure 26.
5. Pull the wheel off the axle.
6. Remove the screws that fasten the two rim halves together. See figure 27.
7. Remove the old tube from the pneumatic tire and replace it with a new tube or replace the entire assembly if it is a solid tire.
8. Screw together the two rim halves.
9. Slide the wheel back onto the shaft. Make sure that the key is in the axle slot.
10. Reinstall the drive wheel nut and washer onto the wheel hub and tighten.

Figure 27. Jazzy 600 XL Drive Wheel Disassembled

11. Inflate the pneumatic tire to 35 psi (2.4 bar) (if equipped with pneumatic tires).
12. Remove the power chair from the blocks.

Figure 26. Jazzy 600 XL Drive Wheel

TIRE

REAR RIM HALF

FRONT RIM HALF

TUBE

SCREWS

DRIVE WHEEL NUT

WASHER

Advertising