Polycom SpectraLink 8002 Series - Manual (Page 4)

4 English
GETTING STARTED
Your SpectraLink 8002 Wireless Telephone uses radio wave technology to
send and receive voice and data transmissions. It is designed to operate
much like a cell phone. However, the handset uses the private
communication system installed in your facility and will not operate
outside the area covered by this system.
Basic Operation
The handset’s Battery Pack must be fully charged before
its first use. Place the handset into the Charger for a
minimum of two hours before using it for the first time.
If you want to Then
Turn the handset on Press and hold the
START
key until two chirps
sound.
Turn the handset off Press and hold the END key. One chirp will
sound. If you are in a call, hang up first, then
turn off the handset.
Unlock the keypad Press the Unlk softkey, then # .
Lock the keypad While in standby mode press FCN , then
Select .
Place a call Press the START key and wait for a dial tone.
Dial the numbers and listen for the ring to
indicate the alerting of the called party.
Note: Line 1 is the default line