Pride Mobility LEGEND CLASSIC XL-8 - Manual (Page 29)

29
Legend Classic XL-8 www.pridemobility.com
V I I . C O M F O R T A D J U S T M E N T S
Figure 16. Armrest Angle Adjustment
ADJUSTMENT DIAL
Seatback Adjustment
WARNING! Do not operate your scooter
with the seatback in a reclined position.
WARNING! Always keep your back pressed
firmly against the seatback while
adjusting the angle.
To adjust the reclining seat:
1. With your back pressed up against the seatback, lift up
on the seatback adjustment lever and lean forward or
rearward to adjust the seatback angle. See figure 15.
2. Release the seatback adjustment lever once the seat is in
a comfortable riding position.
Armrest Angle Adjustment
The armrest angle of your scooter can be adjusted upward or
downward by turning the adjustment dial located underneath
the armrest. See figure 16.
NOTE: The armrests also pivot upward to make getting
on and off of your scooter easier.
Seat Height Adjustment
You can change the seat height to one of three positions in
2.5 cm (1 in.) increments.
To change the seat height:
1. Turn the scooter off and place the manual freewheel lever
in drive mode.
2. Lift the seat up and out of the seat post.
3. Remove the rear shroud.
4. Loosen and remove the seat height adjustment bolt, washers,
and bolt-nut. See figure 17.
5. Slide the upper seat post up or down in the lower seat
post.
6. Align the adjustment holes on the upper seat post and the
lower seat post.
7. Reinstall the seat height adjustment bolt, washers, and
bolt-nut, then tighten.
8. Reinstall the shroud.
9. Reinstall and lock the seat into place.
Figure 17. Seat Height Adjustment
LOWER SEAT POST
UPPER SEAT POST
BOLT-NUT
WASHER
SEAT HEIGHT
ADJUSTMENT BOLT
WASHER
Figure 15. Seatback Adjustment
SEATBACK
ADJUSTMENT
LEVER