Pride Mobility LEGEND CLASSIC XL-8 - Manual (Page 32)

32 www.pridemobility.com Legend Classic XL-8
V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
To release the toggle latch:
1. Push in the toggle latch release button while pulling back the toggle latch. See figures 20 and 21.
2. Position the toggle latch buckle over the top of the toggle latch. See figure 22.
3. Lower the tiller to the scooter floorboard.
TOGGLE LATCH
TOGGLE LATCH RELEASE BUTTON
Figure 20. Toggle Latch (Latched) Figure 22. Buckle Secured Figure 21. Toggle Latch (Unlatched)
TOGGLE LATCH BUCKLE
Figure 23. Frame Positioning
To separate the frames:
1. Push back on the seat post to pivot the rear section rearwards until the rear section is standing vertically on its
bumper. See figure 23.
2. Lift the front section up until the lower pegs are no longer in the slots. See figure 24.
3. Carefully move the front section away from the rear section.
Figure 24. Frame Sections
FRONT-TO-REAR HARNESS
CURVED LOCKING BRACKET
PEG
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 24.
2. Align the lower slots of the front section with the corresponding
pegs on the front of the rear section. See figure 24.
WARNING! Position the front-to-rear
harness so it will not become pinched
between the frame halves when pivoting
the rear section forward. See figure 24.
3. Holding the seat post, slowly pivot the rear section forward
until the curved locking brackets are fully connected onto
the top rear pegs.
4. Raise the tiller.
5. Secure the toggle latch. See figure 21.
! Lower the toggle latch buckle.
! Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear harness and both T-handle bat-
tery harnesses.
7. Reinstall the shroud.
8. Reinstall the seat, and lock it into place.