Panasonic KX-FT934HK - Manual (Page 31)

9. Help
31
9 Help
9.1 Error messages – Reports
If a problem occurs during fax transmission or reception, one of the following messages will be printed on the sending
and journal reports (page 18).
9.2 Error messages – Display
If the unit detects a problem, one or more of the following messages will appear on the display.
Message Code Cause & Solution
COMMUNICATION ERROR 40-42
46-72
FF
L A transmission or reception error occurred. Try
again or check with the other party.
43
44 L A line problem occurred. Connect the telephone line
cord to a different jack and try again.
L An overseas transmission error occurred. Try using
the overseas mode (feature #23 on page 27).
DOCUMENT JAMMED ----- L The document is jammed. Remove the jammed
document (page 36).
ERROR-NOT YOUR UNIT 53
54
59
70 L A transmission or reception error occurred because
of a problem with the other party’s fax machine.
Check with the other party.
MEMORY FULL ----- L The memory is full of received documents due to a
lack of recording paper or a recording paper jam.
Install paper (page 4) or clear the jammed paper
(page 36).
NO DOCUMENT ----- L The document was not fed into the unit properly. Re-
insert it and try again.
OTHER FAX NOT RESPONDING ----- L The other party’s fax machine is busy or has run out
of recording paper. Try again.
L The other party’s fax machine rings too many times.
Send the fax manually (page 18).
L The other party’s machine is not a fax machine.
Check with the other party.
L The number you dialled is not in service.
PRESSED THE STOP KEY ----- L { STOP} was pressed, and fax transmission or
reception was cancelled.
OK ----- L Fax transmission or reception was successful.
Display Cause & Solution
“ CALL SERVICE” L There is something wrong with the unit. Contact our service personnel.
“ CHECK DOCUMENT” L The document was not fed into the unit properly. Re-insert the document. If
misfeeding occurs frequently, clean the document feeder rollers (page 37)
and try again.
L Attempted to send a document longer than 600 mm. Press {STOP} to
remove the document. Divide the document into two or more sheets and try
again.
“ CHECK MEMORY” L Memory (telephone numbers, parameters, etc.) has been erased. Re-
program.
FT932_934HK-PFQX2561YA-en.book Page 31 Monday, May 8, 2006 5:05 PM