Precor EFX534 - Manual (Page 16)

page 16
C O M M E R C I A L P R O D U C T S D I V I S I O N
17. Attach the left and right frame stabilizers. Diagram 10. Proceed with one
side at a time. When you have installed the first stabilizer, perform the same
steps on the opposite stabilizer.
a. Remove four bolts (G) and four washers (H) from the Hardware kit. Place
a washer on each bolt and set the fasteners within easy reach of the unit.
b. Grasp one of the frame stabilizers and align it with the upright support bracket.
c. Insert the four bolts (G) with washers (H) through the frame stabilizer and
upright support bracket. See Diagram 10.
d. Thread all four bolts and washers until the frame stabilizer is secure. Do
not fully tighten the bolts until after the lower section is attached.
e. Perform steps a through d on the opposite side.
Diagram 10 Attach the frame
stabilizers to the
upright support
brackets.
Bolts (G) and
washers (H)
Frame stabilizer
Upper section
Lower section
Upright
support
bracket
Diagram 11 Attach the lower
frame stabilizers
to the base
assembly.
Bolts
f. Carefully, align the mounting holes on the right and left frame stabilizer with
the base frame holes. Insert four bolts (G) and washers (H) on both sides.
Thread the bolts through the unit. See Diagram 11. You may need to adjust
and gently move the stabilizers up and down to get the mounting holes on
both sides of the base frame properly aligned.
g. Tighten the bolts so that the unit is stable, but leave room for final adjustments.
Do not securely tighten the bolts until the unit has been fully assembled.