Inserting the locking pin – Precor EFX534 User Manual
Page 39
page 39
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
In Pause
mode, you
This is what happens...,
resume pedaling Returns to the course and the workout statistics continue from
where you left off.
press Reset
Displays the Workout Summary banner.
exceed time limit The EFX exits Pause mode, resets the displays, and turns off.
In Cool down
mode,
This is what happens...,
no pedaling
or slow pedaling
is detected
Enter Cool down, Pause mode. Workout time stops accruing
and PEDAL FASTER appears on the display. If you enter Pause
mode, it is of limited duration. Check with staff personnel or
refer to
Custom Settings Mode on page 23 and Informational
Displays Prior to Shutdown on page 31.
you press Reset Displays the Workout Summary banner. See Reset on the
previous page.
it ends.
Displays the Workout Summary banner.
At the Workout
Summary
banner, you
This is what happens,...
press Reset
The workout statistics are reset to zero and the EFX shuts off.
INSERTING THE LOCKING PIN
To secure the EFX
after your workout, take the following steps:
1.
Locate the locking pin in its storage location under the ramp. Refer to
Diagram 24 on page 35.
2.
Remove the locking pin from its stored location and insert it into the roller
arm. Position the locking pin so that you insert it from the outside edge of the
ramp toward the inside edge.
3.
Firmly slide the locking pin through the holes in the roller arm. Be sure that the
locking pin is all the way through roller arm. Refer to Diagram 24 on page 35.
Gently move the roller arm to make sure that it is secure.