Plantronics CS60 - Manual (Page 20)

may connect to your line, as determined by the REN, you should contact your local
telephone company to determine the maximum REN for your calling area.
Connection to the telephone network should be made by using standard modular
telephone jacks, type RJ11. The plug and/or jacks used must comply with FCC Part 68
rules. If this telephone equipment causes harm to the telephone network, the tele-
phone company will notify you in advance that temporary discontinuance of service
may be required. But if advance notice isn't practical, the telephone company will noti-
fy the customer as soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
The telephone company may make changes in it's facilities, equipment, operations
or procedures that could affect the proper functioning of your equipment If they do,
you will be notified in advance in order for you to make necessary modifications to
maintain uninterrupted service.
NOTE: If your home has specially wired alarm equipment connected to the telephone
line, be sure that installing the system does not disable your alarm equipment. If you
have questions about what will disable your alarm equipment, contact your telephone
company or a qualified installer.
Industry Canada Notice
TERMINAL EQUIPMENT
NOTICE: This equipment meets the applicable Industry Canada Terminal
Equipment Technical Specifications. This is confirmed by the registration number.
The abbreviation, IC, before the registration number signifies that registration was per-
formed based on a Declaration of Conformity indicating that Industry Canada techni-
cal specifications were met. It does not imply that Industry Canada approved the
equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is marked
on the equipment itself. The REN assigned to each terminal equipment provides an
indication of the maximum number of terminals allowed to be connected to a tele-
phone interface. The termination on an interface may consist of any combination of
devices subject only to the requirement that the sum of the Ringer Equivalence
Numbers of all the devices does not exceed five.
RADIO EQUIPMENT
The term “IC:” before the radio certification number only signifies that Industry
Canada technical specifications were met.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device. “Privacy of communications may not
be ensured when using this telephone”.
19