Philips SCD481 - Manual (Page 10)

adjustable loudspeaker volume
You can adjust the volume on the parent unit to suit your surroundings.
1 Turn the volume control of the parent unit to the volume you prefer (Fig. 18).
Note: When the volume on the parent unit is set to a high level, it consumes more power.
Sound level lights
The parent unit continuously monitors the sound level in your baby´s room and the sound level
lights let you know if there is any activity. If your baby cries, you see the sound level lights light up on
the parent unit.
- As long as the baby unit does not detect a sound, all sound level lights on the parent unit are
out.
- When the baby unit picks up a sound, one or more sound level lights on the parent unit go on.
How many lights go on depends on the loudness of the sound picked up by the baby unit.
- The sound level lights also operate when the parent unit is set to a low volume.
nightlight
The baby unit has a gentle nightlight that helps to soothe your baby back to sleep.
1 Press the baby unit nightlight to switch the nightlight on and off (Fig. 19).
Channel selector
Always make sure that the channel selectors inside the compartments of both units are set to the
same channel. With these channel selectors, you can select sixteen different channel positions. If you
experience interference from other baby monitors, radios, TVs etc. that use the same channel, select
a different channel.
1 Remove the lids of both units.
, Baby unit: (Fig. 3)
- Insert a coin or screwdriver into the groove of the locking knob (1), turn the locking knob
anticlockwise (2) and remove the lid.
- If there are batteries in the compartment, remove them.
, Parent unit: (Fig. 5)
- Slide the lid downwards to remove it.
- Remove the battery pack from the compartment.
2 Use a small, flat screwdriver to turn the channel selector of each unit to the desired position.
Make sure both units are set to the same channel (Fig. 20).
3 Test the connection
If you do not experience any interference when you test the connection, put the battery pack and
the non-rechargeable batteries back into the compartments and reattach the lids.
If you experience interference, set the selectors of both units to another channel and test the
connection again.
accessories
Belt clip
If the battery pack of the parent unit is sufficiently charged, you can take the unit with you inside and
outside the house if you attach the unit to your belt or waistband with the belt clip. This allows you
to monitor your baby while you are moving around.
EngliSh 10