Pioneer VSX-21 - Manual (Page 29)

29
<ARB7181>
SET UP
OPERA
TION
Switching ANALOG/DIGITAL Signal Input
The input of the component set in the digital input setting (Refer to page 20, 21) can be switched to an analog or digital
input signal by pressing the SIGNAL SELECT button.
1
Press SIG. SELECT on the remote control or SIGNAL
SELECT on the front panel to select the input signal
corresponding to the source component.
Each press switches between ANALOG and DIGITAL signal selection.
2
DVD/LD
VCR 1
TV/SAT CD
TUNER
VCR 2 MD/TAPE
TV CONTROL
RECEIVER
DSP MODE
CH.SELECT ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2 3
5
0
6
9 +10
TV/VCR CLASS
7 8
4 1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
RECEIVER TV
MUTING
CN.LEVEL EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
SIG.SELECT
• SIGNAL SELECT is fixed in the “ANALOG” position for components not
assigned to one of the four digital input jacks.
• Because the audio from a karaoke microphone and LD recorded with
analog audio only is not output from the digital output, set SIGNAL
SELECT to “ANALOG”.
• This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and
48kHz), DTS digital signal formats. With digital signal formats other than
these, set SIGNAL SELECT to “ANALOG”.
• When an LD or CD player compatible with DTS is played back with
SIGNAL SELECT set in “ANALOG”, digital noise is output caused by
playing back the DTS directly (no decoding). To prevent noise, you need to
make digital connections (Refer to pages 20, 21) and set SIGNAL SELECT
to “DIGITAL”.
• Some DVD players don’t output DTS signals. For more details, refer to the
instruction manual supplied with your DVD player.
memo
SIGNAL SELECT
Sound Modes
SP SIGNAL
SELECT
ANALOG
SIGNAL
SELECT
ANALOG
A
SP SIGNAL
SELECT
DIGITAL
SIGNAL
SELECT
DIGITAL
A
While SIGNAL SELECT is set to DIGITAL, AC-3 lights when a Dolby
Digital signal is input, and DTS lights when a DTS signal is input
SP SIGNAL
SELECT
DIGITAL
AC-3
SIGNAL
SELECT
DIGITAL
AC-3
A
SP SIGNAL
SELECT
DIGITAL
DTS
SIGNAL
SELECT
DIGITAL
DTS
A
When a Dolby Digital signal is input.
When a DTS signal is input.