ProForm PFANSY9825.1 - Manual (Page 18)

18
46. Identify the Ab Cable (107). Route the small ball
on the Cable through the Leg Lever (4) and the
Right Seat Frame (3).
Make sure the Cable is
over the rod in the Seat Frame.
Attach a 90mm Pulley (63) inside the Leg Lever
(4), over the Ab Cable (107), with an M10 x
65mm Bolt (77), two M10 Washers (99), two M10
x 12mm Spacers (101), and an M10 Nylon
Locknut (90).
48. Route the Ab Cable (107) through the Right
Upright (2) and under a 90mm Pulley (63). Attach
the Pulley and two Half Finger Guards (66) to the
Right Base (1) with an M10 x 50mm Bolt (64) and
an M10 Nylon Locknut (90).
Make sure the
Finger Guards are oriented as shown.
49. Wrap the Ab Cable (107) over a 90mm Pulley
(63). Attach the Pulley, a Cable Trap (68), and
two Half Finger Guards (66) to the lower hole in
the indicated “U”-bracket (50) with an M10 x
50mm Bolt (64) and an M10 Nylon Locknut (90).
Make sure the Cable Trap and Finger Guards
are oriented as shown.
47. Attach a 90mm Pulley (63) inside the Right Seat
Frame (3), over the Ab Cable (107), with an M10
x 45mm Bolt (80) and an M10 Nylon Locknut
(90).
46
47
48
49
63
99
99
77
90
4
3
101
107
Large
Ball Rod
101
3
107
107
63
80
90
64
90 66
66
1
2
63
107
50
63
66
66
90
64
68