Paxar Sierra Sport3 - Manual (Page 24)

2-8 Operator’s Handbook
L o a d i n g F a n - F o l d S u p p l i e s
Use these instructions to load fan-fold supply.
1. Pull the release levers located on both sides of
the printer to open the supply door.
2. Insert the 3-inch core in between the supply
holder tabs to open them to their widest position.
3. Place a stack of fan-fold supplies behind the
printer, printing side up.
4. Slide the supply guides, located inside the printer
on each side of the external supply slot, out to
their widest position.
5. Feed the fan-fold supply, printing side up, into the
supply slot on the back of the printer.
6. Center adjust the supply guides so that they
barely touch the edge of the supply.
7. Pull out enough supply to lay across the exit
chute.
Supply slot