Paxar TC6037EM User Manual
Page 9
Using Batteries 2-3
2. Turn the printer upright, holding your palm beneath the open battery
compartment. Hit the printer on your hand and catch the battery as it
slides out.
3. Insert a new battery into the compartment (non-ribbed end first).
4. Slide the compartment door shut. You will have to press the battery
in slightly so the door fits over it. When the door shuts, you hear it
click into place.
U s i n g t h e B a c k u p B a t t e r y
You should have received a printer with a coin cell
battery already installed in the printer.
The backup battery is a 3-volt lithium coin cell.
You can buy additional backup batteries at most
stores, part # CR2032.
NOTE: You must use a fully charged main battery when replacing the
coin cell.
You must turn the printer on, wait until the printer fully
initializes, then turn the printer off again. This will help to further
reduce the coin cell life.
Switch backup batteries when you receive a CMOS error.
Main
Battery