Philips DVP3200V/37B - Manual (Page 30)

English
30 DVD to Videotape Duplication
Follow the steps below to copy a DVD to a videotape. This will
be possible only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the
tape’s record tab is intact and the tape is long enough to record
the DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so VCR light appears on the front of the DVD/VCR.
● Turn on the TV and set it to channel 3, 4 or its Video Input.
1 Point the remote control at the DVD/VCR. Press
Number buttons 0, 0, 3. “DISC” will appear on the TV
screen.
2 Press REC MODE repeatedly until the desired tape
speed (SP or SLP) appears briefly on the screen.
Details about tape speed are on page 67.
3 Press REC I to start recording. “REC” will appear on
the display panel.
4 Press DVD. Press PLAY B to play the disc.
5 To pause the recording, press VCR, then press
PAUSE k once. “REC” will flash. To resume
recording, press REC
I or press PAUSE k again.
“REC” will reappear.
6 To stop recording, press VCR, then press STOP C.
DISC
TV/VIDEO VCR DVD VCR Plus+
SUBTITLE AUDIO ANGLE ZOOM
DVD
SETUP MENU
DISC/VCR
DISPLAY
TIMER SET
BACK
PLAY
REW FFW
PREV NEXT PAUSE
REC STOP
OK
REPEAT
REPEAT
A-B
CH
+
-
CLEAR
REC MODE SEARCH MODE TITLE
• A timer recording is not
possible during DVD to
videotape duplication.
• You cannot copy a DVD to a
videotape if you are using
Progressive Scan. Details are on
page 14.
Helpful Hints
1
2
5,6
5
3,5
4
6
E8A21UD_EN1 5/29/06 3:13 PM Page 30